Jeeper  Adventures Under the Hood  Jeeper

A Diagnostic Tool


The diagnostic connectors on the firewall enable you to monitor the major components of the computer-controlled emission system, that is, if you have the necessary diagnostic tool. Here is a picture of one that I cobbled together using parts from my many junk boxes. The only things I had to buy were the Molex connectors. The 0-1 volt meter shows the actual output voltage of the O2 sensor, and the vertical column of LEDs shows the state (on or off) of the signals available at the diagnostic connectors on the firewall. The cables (telephone cord) are long enough to reach through the side window to the dash inside the Jeep. This way I could watch what was going on as I was driving and catch a malfunction "in the act." Diagnostic Tool



A simpler, smaller, and cheaper diagnostic tool

The two signals that provide the most useful information are A and B, which actuate the stepper motor on the BBD. The behavior of these two can tell you a lot:



A small tool to monitor the A and B signals can be built in an hour for almost nothing. Here's all that's required:
  • Two LEDs (any appealing color)
  • Two 470 ohm resistors ( watt)
  • A small project box to put them in.
  • Some wire
  • A soldering iron and solder
Parts


Here's a diagram showing how it's wired. There's nothing to it. Three wires come out - A, B, and ground. Hook A and B to the appropriate wires at the harness connector under the dash and the ground wire to any good ground. Which LED is A or B doesn't matter as long as you remember which is which. I recommend three different wire colors to avoid confusion.

I decided to tap into the harness right at the MCU, since it's only a foot away from the spot under the dash where I decided to semi-permanently mount the tool, and there seemed to be no point in going through the firewall to get to the diagnostic connectors on the other side.
Wiring Diagram


Here is what the finished project might look like. I already had the LEDs and resistors, and bought the rest at my local Radio Shack for less than five dollars. Project


If you don't have a box and/or would rather just cobble it together, you can punch holes in a piece of cardboard, push the LED leads through, and wire the resistors on the back side, using liberal amounts of insulating tape to hold it together. Picture
Here is what the tool will show under normal operating conditions.
As the MCU energizes the stepper motor on the BBD, moving the metering pins forward and backward in an effort to correct the mixture in response to the voltage from the O2 sensor, the pattern will look something like this. The pattern provides clues as to what's going on with the computer and with the carburetor. If it's stuck at one end for instance, you can tell immediately if it's too rich or too lean, which gives you valuable information for finding the problem. If it displays something that looks similar to what is shown here then the whole system is probably working as intended.
If you look down the carburetor while watching the LEDs, you will understand immediately what's going on.
Diagnostic Tool
Taking it a step further.
If you are not intimidated by this little project, or even if you are, it can be expanded to include all the signals available at the D2 diagnostic connector by simply adding a resistor, LED, and wire for each one. You could skip pins 4 and 7, and pin 1 too if you don't have the PCV shutoff solenoid (you shouldn't have this).

From a performance standpoint, and in rough order of importance, the key signals are: Bear in mind that in these simple circuits some of the LEDs will be normally on, and will go off when actuated, while others will be normally off and will light when actuated. This can be confusing at first, but you will quickly learn what to look for.
I compensated for this in the diagnostic box at the top of this page by using CMOS inverters to drive some of the LEDs, but that's considerably more complicated, requires a lot more parts, and is time-consuming.
Back to Table of Contents